This adjustment setting control is for the model “GR” swing arm cutting machine.
When the switch is turned to “I” position,the motor will start up and the signal led will light up.When motor rotation has reached its maximum rate,the clicker press swing arm will rise to the height preiviously set using the handwheel .
CLOCKWISE DIRECTION: The arm will be lowered
ANTICLOCKWISE DIRECTION: The arm will be raised
Donot force handwheel rotation at the end of either setting to avoid damaging the mechanism.When the arm is being lowered,keep hand well chear of the machine to avoid crushing between the arm and the cutting board.
When the arm is raised in work position,it can be both to the left and right ,using the two knobs which contain the two push-buttons that control the die cutting machine action.this is a two-handed control system ;both button must be pressed at the same time to lower the swing arm.If the buttons are pressed with a difference of more than three tenths of a seond,the lowering action is deactived.It is impossible to active the press using a single button.
The release of one or both buttons will provoke the arrest of the descent action and return of the arm to its work position,otherwise the arm down stroke will finish at the dies.
When the work cycle on the press is compeleted,turn the swith back to “0” position,and donot leave the cutting machine unattended until the arm has returned to its rest position.