Presumably everyone are not very familiar with the plane hydraulic cutting machine, especially the layman, now Gerson machinery are speaking about the plane cutting machine adjustment key points :
1. After plane Cutting machine cutting die set work completion,put the material on cutting board then cutting die is placed on the material, At last push feed plate into the cutting area for die cutting.
2.While both hands pressing the cutting switch, then pressing board of cutting down pressure on cutting die,then cutting die cut material automatically back up to the starting position before the stop.
3.While punching of materials, such as materials are not fully cutting, adjust the cutting depth of the controller, the “pressure” system to rotate clockwise reverse direction.If cutting die into the cutting sheet is too deep, then the “pressure” system to rotate counterclockwise. Adjust the longer the cutting depth of the deeper, trying to adjust to cutting die slightly pressed into the plastic cutting sheet .
4. Feed plate will pull out the cutting area, remove the finished materials to complete a punching process .
Note: the loop hydraulic unites, structure and working principle of attachment must be certainty. Combined to be a specific analysis of the hydraulic system working process conditions, see the selection of hydraulic unites and attachment whether to meet the needs of the work of the loop or not.
In some cases of the hydraulic circuit, the request with a hydraulic element as a hydraulic pump, and sometimes as a hydraulic motor. Obviously, not all of the hydraulic pump or hydraulic motor, can meet this requirement.
