Die Cutting Machine
38 Years+ Manufacturer
Quote Now

How to setting the die height for beam die cutting machine

After you installation and test Gerson GRB beam cutting machine without die,or change the die (The new die height is not the same as previously used),You need to seet the die height before doing die cutting work.

The following step Gerson recommend for GRB beam cutting machine:

1. Clean the dirt on the work surface (pp)cutting board, and place the die in the middle of the (pp)cutting board.
2. After the machine starts, loosen the setting handle, and rotate “pressure control” left to zero.
3. Rotate the “die setting” switch right to “setting”, upper cutting press board begins to go down slowly. And stop automatically when gets close to the die.
4. Loosen the setting handle and push to the bottom, and tighten it. Turn the “DIE SETTING” switch (left) to “DIE” position.
5. press”urgently stop” button, the cutting press board will rise to the top immediately, and now the die setting is completed.
Note: when use die or (pp)cutting boards of different heights, must setting the die height again. Otherwise, it may damage the (pp)cutting board even the machine.

Have Question? Ask Now