Die Cutting Machine
38 Years+ Manufacturer
Quote Now

Gerson GR clicker press ADJUSTMENT SETTING CONTROLS.

Gerson GR clicker press ADJUSTMENT SETTING CONTROLS.

Gerson GR clicker press ADJUSTMENT SETTING CONTROLS.
Gerson GR clicker press ADJUSTMENT SETTING CONTROLS.

1.Start up switch.
2.Signal led : machine ON.
3.Right hand push button.
4.Left hand push button.*
5.Handwheel for setting height.
6.Pressure setting.*
7.Cutting method switch

*Optional:programmable push button panel.

When the switch (1), is turned to “I” position, the motor will start up and the signal led (2) will light up. When motor rotation has reached its maximum rate, the mobile arm will rise to the height previously set using the handwheel (5):

CLOCKWISE DIRECTION:The arm will be lowered
ANTICLOCKWISE DIRECTION:The arm will be raised.

Do not force handwheel rotation at the end of either setting to avoid damaging the mechanism.When the arm is being lowered, keep hands well clear of the machine to avoid crushing between the arm and the cutting plate.

When the arm is raised in work position, it can be rotated both to the left and right, using the two knobs which contain the two push-buttons that control the die cutting action. This is a two-handed control system; both buttons must be pressed at the same time to lower the mobile arm. If the buttons are pressed with a difference of more than three tenths of a second, the lowering action is deactivated. It is impossible to activate the press using a single button.

The release of one or both buttons will provoke the attest of the descent action and the return of the arm to its work position, otherwise the arm down stroke will finish at the dies.’

When the work cycle on the press is completed, turn the switch (1) back to “0” position, and do not leave the machine unattended until the arm has returned to its rest position.

Have Question? Ask Now