Wheather the cutting press is packed in an open or closed crate or packing case,it must be raised using chains or cables which are adequate for the combined weights of die cutting machine and case.
The chains or cables must be passed under the packing crate in the points shown by the arrows ub tge drawing .To place the press in position ,proceed as follows:
1) Remove the packing crate and the plastic protective film
2) Remove the three bolts which attach the cutting press feet to the pallet
3)Raise the cutting press by hooking up the eyebolts,remove the pallet and plase the press on a fork lift to transport it to its position.
Before placing the cutting press in position,check that the floor is level ,and clean of all oil or viscous liquids .The cutting machine does not need bolting to the floor,where necessary ,it is sufficient to insert rubber squares between the feet and the flooring.The squares must have the correct degree of elasticity,if they are too soft the weight of the machine will flatten them and they will loose their absorbing effect,if the are too hard,the machine will slip.
4)Now the cutting press can be placed in position.
