Cutting Machine start Adjustment
The following is for Gerson GSB serial die cutting machine.
1.Adjust the delay locator or timer to the minimum.
2.Place the cutting material on the cutting board.
3.Place the cutting die on the material.
4.Move the swing arm over the cutting die,Let swing arm aligned with the center line of the cutting die.
5.Rotate the handwheel (clockwise arm down, counterclockwise rotation arm up), let the distance between the arm and the cutting die approximately 10mm.
6.Open motor operation switch, the motor is operating normally.
7.The two hand hold each press button and give a trial cutting.Rotate the locator or timer knobs to cutting material properly.If cutting die cut into board too much ,adjust locator or timer knobs smaller.on the contrary, adjust larger.Locking knob and then start to work (If change the cutting die, The press need to adjust again.The grid voltage fluctuation affect the cutting depth).