Die cutting instructions for clicking press model “GR”.
Single setting control panel
1) turn the main switch to start up the press ;the arm will rise.
2)Select the cutting method (pressostate or timer) for clicker press.
3)Move the arm to one side to leave the cutting plate free ,spread the material to be cut,and place the dies on top of the material.
4)Turn the arm so that it covers the whole die ;turn the handwheel in a clockwise direction to bring the arm down to 8 mm from the die.
5)Set the cutting pressure or cutting time using command(3),accoring to the type of cutting die or material to be cut.
6)Press button P1 and P2 at the same time to command cutting action.
7)After the cutting action,the arm will rise ;move the arm to one side in order to remove the cut material .
Programmable panel
The cutting action is the same as the single setting function except that button P1 must be pressed at the same time as one of the three buttons P2 ,P3 and P4 according to the respective values programmed on the potentionmeters R2 ,R3 and R4.
In both cases ,make sure that the arm stroke hits the centre of the die during the cutting action to prevent all danger of the spitting out and causing serious injury.